Where to sell self-leveling epoxy floor paint? Self-leveling epoxy floor paint Construction Notes: 1. Self-leveling floor construction environmental requirements: dry ground temperature should be lower than 10 ℃, ground relative humidity should be maintained below 90%; no snow, do not have too strong drafts, so as to avoid premature drying topical. If the hot summer temperature is high, should choose nighttime construction. 2. Self-leveling construction of water is best clean water, to avoid affecting the perception of the quality of the surface. 3. After the second channel self-leveling floor brush interface agent and former self-leveling construction, surface and interface requirements for agents to be dry for better connectivity. Construction should pay attention to maintaining ventilation; interface agent intolerance of cold, low temperatures, storage and transportation should be insulated. 4. Self-leveling face higher requirements grassroots grassroots not have loose concrete, grease, debris, dust net absorption; on the ground floor drain, waste, and other sub-lattice seam sealed first with a sponge; the original cushion stay dividing joint with self-leveling mortar required the same material will be closed. 5. Where to sell self-leveling epoxy floor paint? Self-leveling floor construction must be continuous, not stop in the middle; add water after use for 20 to 30 minutes, more than self-leveling mortar will gradually solidified to produce strength and lose mobility. Pouring width thickness depending on the capacity of the pump and spread out, and generally no more than 10 to 12 meters; too broad ground sponge separated into small pieces required construction. For industrial requirements particularly smooth surface, pouring narrower width. 6. The self-leveling floor under cold conditions, use warm water (water temperature does not exceed 35 ℃) stirring.